Advertisement

There are two ranges of sounds. One is the high range sound and the other is the low range sound. The high range sounds can be handled at speakers in the rear end, dash and door panels of the vehicle. But the lower tones and the bass effects are generally handled by the sub woofer which has got no other substitute. One should ensure that the sub woofers are wired properly. But how to wire dual sub woofer?

There are few tools required for accomplishment of this task. The usage of such tools will reduce the man power required and makes it easy to complete the task. It may include amplifier and dual speaker.

The first step is to check the impedance of the sub woofer. They come in many ranges of resistances or impedance. Four ohm and two ohm are the most common ranges available. This sub woofer may also be of dual voice coil they don have variations that are unusual. The very common type of sub woofer under using is the four ohm range. And so the plans for wiring are all designed so as to match this kind of sub woofer.

The woofer can be placed either in the cargo area at the rear back or the car’s trunk in the case of models like hatch backs or SUV .There are channels in the amplifiers. Then the amplifier position is located after which the manual is gone through for any kind of procedure to be followed.. To these channels the wire from the sub woofer is connected. The ends of these wires are stripped by ? an inch.

The positive wires are then connected to the positive terminal and in the same way the negative terminals connected with the negative wires. That is in general corresponding connections between sub woofer input and the amplifiers are made. These steps are repeated with the amplifier’s left channels and the second sub woofer.

Amplifiers and sub woofers have different kinds of terminals. Push terminal is the most common type of terminal. This terminal pushes a small lever an a hole is generated. And the wire is slipped through this. A mono amplifier can also be used to wire a sub woofer. The step 2 is followed once again. The amplifier’s positive terminal is connected to the first sub woofer’s positive in the same way the negatives are also connected. These are repeated and also known as Daisy chaining often.

Check your sub woofers by playing a track of your choice. If you feel that the bass is not good enough check for all the wiring so as to ensure that there is no wrong connection made between negative and positive. Such a wrong wiring may lead to poor sound quality and also make it play out of phase. This should be avoided.

One should always know how to wire dual sub woofer, so as to have their car stereo and sub woofer working in a proper condition and to enhance good sound quality.

---

Find the best Auto parts at bargain prices and much more information on Car Audio for the right music system. Powernetshop.at have the best product evaluation on the internet.

You are reading Correct Wiring Of A Dual Voice Coil Subwoofer on BloggingStuffs.com.